Vector Welding TIG DC 200A Inverter IGBT Welding Machine with HF Ignition
Thanks to the adjustable AC / DC (alternating current / direct current) mode, it can be used for all weldable metals, including aluminum.
With 10-200A in TIG mode, 10-170A in MMA / electrode mode and plasma cutting with 10- 50A the unit is well suited for installation, repair, maintenance and DIY.
3 in 1 combined device: TIG AC / DC, MMA / STICK, plasma cutting
TIG AC / DC welding: Treatment of all weldable metals, including aluminum
The adjustable AC output frequency allows the operator to focus the arc, minimizing the heat affected area.
Advanced AC balance control helps maintain a sharp tungsten needle to precisely control the arc in the weld joint.
Pulse function: During pulse welding, the welding current alternates between the output current and the peak current at the desired frequency. The longer the intervals, the less energy and heat are supplied to the workpiece
HF ignition (TIG)
2T / 4T
MMA / STICK / E-HAND: Coated electrodes are used - in this process the electrodes are both arc carrier and filler metal.
Hot Start: each time the welding machine is restarted, an overcurrent is supplied to promote the ignition of the arc.
Arc-Force: the molten material is transferred more easily to the part. Prevents the extinction of the arc if this material causes contact between the electrode and the molten pool.
Anti-Stick: Automatically turns off the welding generator if the electrode sticks to the workpiece and needs to be removed by hand without damaging the electrode clamp.
Plasma cutter: CUT function using a plasma beam generated by electricity. This melts the material and removes it with compressed air - a precise cut is produced. With this method, all conductive metals can be cut (e.g. steel, stainless steel, aluminum, copper, etc.)
Cutting thickness: maximum 16 mm (hand guided), quality cut 10 mm (hand guided) Modern IGBT (Insulated Gate Bipolar Transistor) allows fast switching and therefore low loss of electric currents
Welding current adjustment range (TIG mode) 10-200 A
Welding current adjustment range (MMA / STICK mode) 10 -170 A
Welding current adjustment range (CUT mode) 10 - 50 A
Welding current duty cycle (ED) TIG 40 ° C 200 A at 18 V 4A at 18 V 40%
operating time (ED) MMA / STICK 40 ° C 170 A at 26.8 V 25%
operating time (ED) Plasma cutter 40 ° C 50 A at 96 V 40%
Mains voltage 1 x 230 volts
mains frequency 50 - 60 Hz
protection class IP23
dimensions in mm (L x W x H) 380 x 160 x 405
Weight in kg 9.5
EN60974-1 / EC60974-1 standards
Maximum cutting capacity (hand guided) 12 mm
Quality cutting capacity (hand guided) 8 mm
No posts found